Based in Langley, WA · serving Whidbey Island, Camano Island and the Skagit side
Roofing · Siding · Free Estimates (360) 544-9655
Whidbey Roofing and Siding (Culver Built Siding and Roofing) logo
Roof Flashing Repair in Langley, WA
Our Services

Roof Flashing Repair in Langley, WA

Roof Flashing Repair · Langley, WA

Metal flashing replaced at chimneys, walls, valleys and vents

Roof flashing repair replaces the metal that seals the joints in a roof. It sits where a roof meets a chimney, wall or dormer, in each valley and around vent pipes. The asphalt shingle industry's trade group calls flashings the most vulnerable points on a roof. When a leak traces back to one of them, the roof repair is new flashing.

We are based in Langley and work Whidbey Island end to end, plus Camano Island and the nearby mainland. We repair flashing on asphalt shingle and standing-seam metal roofs, on homes, shops and barns. The estimate is free, so call or text (360) 544-9655 and we will get back to you.

What We Handle

  • Chimney flashing replaced: apron, step and counter flashing and the back pan
  • Crickets added on the uphill side of wide chimneys
  • Step flashing replaced along sidewalls and dormers
  • Kick-out flashing added where a roof edge runs into a wall
  • Valley metal and valley linings replaced on shingle roofs
  • New boots on plumbing vents where the rubber collar has cracked
  • Drip edge replaced along the eaves and rakes
  • Trim, flashing and pipe boots repaired on standing-seam metal roofs

Free Roof Flashing Repair Quote

Tell us about the job. We will get right back to you.

Where does roof flashing fail on Whidbey Island homes?

Flashing fails where water gathers or runs into something in its way. A valley carries runoff from two roof planes, which a shingle industry manual says makes it especially vulnerable to leakage. Chimneys, walls and pipes all break the roof surface, so each needs metal worked in with the shingles. Skylights carry their own flashing kits, so we trace and repair those leaks as part of our skylight work.

Island County's severe weather plan says the county is most susceptible to severe wind. That wind drives rain under loose metal, and fir needles pack valleys and the uphill side of chimneys. Salt air off the water works on old metal, and sealant dries out and cracks. If a storm rips flashing loose and water is coming in, start with emergency roof repair.

Siding run tight to the roof with no kick-out flashing sends water down the wall instead of into the gutter. Washington's residential code calls for a flashing that diverts water away where a roof eave meets a sidewall. A federal building guide says wood siding often shows that leak as peeling paint or stains. Fiber cement and vinyl can hide it for years.

Chimney flashing repair: step, counter and cricket

Chimney flashing is a set of parts. Apron flashing runs across the downhill face, and step flashing climbs each side under the shingles. Counter flashing is fastened to the chimney and laps down over them. The chimney and the roof can move separately, and that overlap lets them shift without opening a gap.

On the uphill side, a back pan or a cricket turns water around the chimney. The code calls for a cricket there on any chimney more than 30 inches wide, measured across the slope.

On a shingle roof, the code says chimney flashing goes on per the shingle maker's printed instructions. We take off the old metal and the shingles that lap it, then rebuild the flashing with new shingles. Brick, mortar and the crown go to a mason.

Flashing on metal roofs, walls and dormers

Where a roof runs into a wall or a dormer, step flashing does the work. Each piece tucks under a course of shingles and turns up the wall. On shingle roofs, the code sets that flashing at least 4 inches high and 4 inches wide. Its vertical leg runs continuously under any siding.

So a sidewall flashing repair opens the siding just above the roof. A federal building guide sets the order: roofing and siding off, new flashing in, house wrap lapped over its top. Damaged boards get siding repair, and soft wood behind the old flashing gets wood rot repair.

On a metal roof, the flashing is trim matched to the panels at eaves, rakes, valleys, walls and chimneys. Pipes come through boots that seal against the panel. Washington's residential code calls for corrosion-resistant metal flashing, at least as thick as No. 26 galvanized sheet.

Installer at the eave of a new green standing-seam roof where two roof sections meet, new cedar trim on the gable Cedar barn with a new green standing-seam roof, ridge cap and green rake trim over new cedar fascia

Ready to get started?

Free, no-obligation estimates across Whidbey Island, Camano Island and the Skagit side.

(360) 544-9655
How We Work

How a Job With Whidbey Roofing and Siding Runs

From the first call or text to the last of the old roofing hauled off, here is how it goes.

1

Call or text us

Reach us at (360) 544-9655 and tell us what the roof is doing. We set a time to come out and look at it.

2

The look and the estimate

We get up on the roof and check the decking, flashing, venting and gutters. Then you get the scope and the price in writing. The estimate is free.

3

Materials and colors

You pick the shingle line and color, or the metal panel profile and color. Our shingle color page shows every CertainTeed color side by side. We order the material and set a start date around the weather.

4

The crew does the work

Tear-off comes first, then decking repair where the wood is soft. Underlayment, flashing, the new roof and the venting go on in order.

5

Cleanup and the finished roof

The old roofing leaves with us and the ground gets cleaned up. Then we go over the finished job with you and hand over the paperwork.

FAQ

Roof Flashing Repair Questions, Answered

Common questions about roof flashing repair across Whidbey Island, Camano Island and the Skagit side. If yours is not here, call or text and ask.

Call (360) 544-9655

How often should roof flashing be replaced?
There is no set schedule. A home inspectors' association says undamaged flashing can last a long time, but its connections tend to fail. On a re-roof, Washington's residential code says flashing gets replaced where it is rusted, damaged or deteriorated.
Can you repair flashing without replacing the roof?
Usually, yes. We open the shingles around the failed flashing, put in new metal and close it up with new shingles. A federal building guide says roof-to-wall flashing can be replaced as a stand-alone retrofit. If the whole roof is worn out, a roof replacement puts new flashing everywhere at once.
How do you fix a leaking roof vent flashing?
We replace the boot, because the rubber collar cracks with age and caulk over the crack does not hold. The new boot slides over the pipe. Shingles above lap over it, and its lower edge laps over the shingles below. A shingle industry manual says to check these boots for cracks once a year.
Is caulk enough to stop a flashing leak?
Not for long. A builders' trade journal says caulk should not be the main barrier against water on a roof. A chimney and a roof expand and contract at different rates, and that movement cracks a caulk joint. Flashing sheds water because each piece laps over the one below it.
What does roof flashing repair cost?
Price follows where the flashing is and what has to come apart to reach it. One vent boot is a small job; a chimney that needs a cricket is a bigger one. Rot under the old metal and a steep pitch add to it. Call or text (360) 544-9655 for a free estimate, and see our roof repair cost guide for published market ranges.
Do you repair the chimney itself?
No. We replace the metal around it: the step, counter and apron flashing, the back pan and the cricket. Brick, mortar and the chimney crown are a mason's job. If we spot crumbling mortar or loose brick, we point it out so a mason can repair it.
More From Whidbey Roofing and Siding

Work That Pairs With Roof Flashing Repair

Storm-damaged porch roof with a broken gutter hanging off the eave

Roof Repair

We repair roof leaks, failed flashing, wind-lifted shingles and storm damage on Whidbey Island homes. Every job starts with a look at the roof and a free estimate.

Learn More
New skylight set into a cedar-lined vaulted ceiling in a Whidbey Island home

Skylight Installation

We install new skylights and replace fogged or leaking ones on homes, shops and outbuildings. Each skylight gets a flashing kit tied into your shingle or standing-seam metal roof.

Learn More
Rebuilt patio cover framing with new painted beams and posts, seen from inside the house

Rot Repair

Dry rot and wet rot in fascia, soffits, sills, siding and the framing under carports and patio covers. We cut back to sound wood, fix what let the water in, and paint the repair to match.

Learn More
Why Choose Whidbey Roofing and Siding

Built for Roofs on Whidbey Island

Based in Langley

We work from the south end of Whidbey Island. Our crew starts the day here, so a ferry wait never sits in front of your job.

More than 30 years of experience

We put 30-plus years of building and roofing experience on the island behind every job. It shows in the details: flashing, venting, decking and the trim around them.

Licensed, bonded and insured

We are licensed, bonded and insured in Washington, under contractor license CULVEL*828N4. That covers the roofing, siding and exterior work we do on the island.

Free estimates

We look at the roof in person, then put the scope and the price in writing. The estimate is free, and it says what we found up there.

Google Reviews

5-Star Rated on Google by Whidbey Island Homeowners

Real reviews from real roofing and siding jobs on Google.

Read All Reviews

They installed a new metal roof on the house we purchased and were able to start quickly which meant it was nearly done by the time we moved in. We had a great experience working with Jeff who was very helpful with suggestions on some cosmetic changes we made and the entire roof and gables came out nicely. Very pleased with this company and would recommend them to anyone on Whidbey looking for roofing or siding work.

David Crabtree2 months ago · Google review

Whidbey Roof and Siding did an outstanding job. Very professional! No playing games came in with the lowest bid. We did run into a few surprises, but Jeff was very clear and transparent about what it would take to correct the issue. Very glad I had someone who could deal with the issues. As one recent visitor said the skylight looks like it was here all along and not an after thought addition. Highly recommend

Timothy Lawrence2 months ago · Google review

What a class act. You only have to mention what you want. And it will be done better than expected. We have used them multiple times. I can’t imagine using anyone else for a future projects.

Free Estimates

Get In Touch With Whidbey Roofing and Siding

Tell us what is going on with your roof, siding or gutters and we will get back to you. You can also call or text (360) 544-9655.

  • (360) 544-9655 · call or text
  • Langley, WA · serving Whidbey Island, Camano Island and the Skagit side
  • Free estimates · roofing, siding, gutters, windows and doors

Get a Free Quote

Tell us about the job. We will get right back to you.

Call (360) 544-9655